PI2NYV Repeater

De opzet van de Dorpsrepeater Gem. Hellendoorn is een initiatief door Sascha PF9Z en Fred PA3SHF

De analoge 70cm repeater bevindt zich aan de rand van de Sallandse Heuvelrug. En werkt met een Motorola Quantar welke via een eigen controller wordt aangestuurd. Deze voorziet in een afwisselende spraak en “active” VOICE identificatie.

Specificaties:

Frequentie 438.100 MHz
Shift -7.6 MHz
CTCSS 77,0 Hz voor RX & TX
TX Power 15Werp
Antenne X510
Antenne hoogte(nap) 34m

Het beheer en onderhoud van deze dorpsrepeater is in handen van het Pi4NYV Dorpsrepeater team.

Gebruikt u de repeater Pi2NYV?…en heeft U suggesties of wilt U een bijdrage of eventueel een sponsoring leveren, dan is dat natuurlijk heel erg welkom. Mail naar info@Pi4NYV.com

Onder deze fantastische foto van de repeater antenne staat nog wat informatie betreft de apparatuur.

REPEATER EQUIPMENT & TECHNICAL SPECIFICATIONS:

Motorola Quantar UHF 430-470mHz Repeater

Duplex & extra Bandpassfilters:

Our Repeater Controller:

Technical Specifications:

  • No need for COR/COS signal with a built-in squelch circuit.
  • Polarity inversion protection.
  • Low current drain.
  • Quieter audio.
  • Selection for flat or DE-emphasized audio.
  • user-friendly interface.
  • RJ45 connections.
  • Comes with case, bracket mount, two cables with connector, instruction manual, nuts, and bolts.
  • 6 LEDs for PWR, RX1, TX1, RX2, TX2, and DTMF.
  • Dozens of functions with a great variety of options.
  • Four-digit password.
  • Keeps all configurations in case of power failure.
  • All functions controlled over the air by DTMF tones.
  • Audio confirmation of the commands.
  • Digital audio recorder for ID and announcements.
  • Morse and voice ID.
  • Smart ID.
  • Multi-function button.
  • DTMF mute function.
  • Auxiliary audio port for link and out-of-band operation or control.
  • Quindar Tone courtesy beep (Apollo mission control beep).
  • Roller beep changes the courtesy tones automatically.
  • 14 special beeps and hundreds more with the beep editor.
  • All timers user-programmable.
  • CTCSS input logic for each port.
  • Adjust for squelch, audio RX1, TX1, RX2, TX2, voice, and beep.
  • 6 operation modes.
  • 2 alarm inputs.
  • 6 remote control outputs.
  • Timed fan output.
  • Carrier and audio test function.
  • Comes with case, mount bracket, cables, and instruction manual.
  • Power requirements: 8V – 15V DC, 18mA standby/max 70mA at voice announcement.
  • Board dimensions: 104mm x 80mm x 16mm (case: 111mm x 80mm x 26mm).
  • Test functions included.
Translate »